Also, be sure to purchase screws that will go well with the toggle bolt size you choose. You will need one or two toggle bolts per television. Next, you need to head over to your local hardware store and pick up a little bit of mounting hardware. If it just pulls out of the wall, or you can use a drywall saw or drill bit to cut into it, then your wall is not load-bearing. It doesn’t have to be too heavy, just something to test the strength of your wall. Use a piece of lumber or even something like an iron skillet filled with water. The best way to determine if your wall carries weight is by hanging something heavy off of it. Without getting too technical, it’s usually fairly easy to spot a load-bearing wall. Load-bearing walls are just what they sound like – they support the weight of things on them. Next, you need to determine if your wall is load-bearing. However, if your wall is masonry brick, concrete block, it’s not possible to drive screws into the surface without additional measures like toggle bolts or drilling holes and using anchors. If your wall contains either lath or plaster, you can most likely screw directly into the material with no need for studs. If you’re not sure, look for screws on the wall’s surface near electrical outlets and picture frames that appear to be structural supports. Most newer homes have a stud-and-drywall construction, but it’s essential to check.
Step to Follow on How to Mount a TV on a Lath and Plaster Wall Step One: Determineįirst, you must determine if your wall is lath and plaster or solid masonry. This blog post will go over how to mount your TV onto a laminate or plasterboard wall without drilling any holes – which means no damage! And if you’re looking for instructions on mounting your TV onto brick or cement walls, check out our other blog posts about those types of surfaces. It can be challenging to find a stud in this type of wall, but there are some tricks that you can use to make it easier for you! This is an essential step in homeownership because many people’s TVs are mounted on the wall instead of placed on a stand or table. This blog post will go over how to mount a TV on a lath and plaster wall.